Voriges Thema

Nächstes Thema

Quick installation

By following the procedure below, you can install the end device in your network environment in just a few minutes:

  1. Connect the end device to a VGA or DVI monitor, an AT-compatible keyboard with a PS/2 or USB connection, a USB mouse and the LAN using an RJ45 connector.
  2. Connect the end device to the power supply.
  3. Switch on the end device and wait until the graphic desktop is launched.

    You are now logged on as a user with the name user (password is user).

To log on as an administrator, proceed as follows:

  1. Select Start > Log Off.

    - with W7, holding down the Shift key -

  2. Hold down the Shift key and click on Log Off.
  3. Hold down the Shift key until the logon window is shown.
  4. Log on as an administrator user with the password administrator.

    Change the administrator password after logging on for the first time!

    A yellow IGEL symbol is shown in the Windows taskbar:

You can configure basic system settings here.

  1. Right-click the IGEL symbol.

    A pop-up menu opens.

  2. Change the
  3. Click OK to save your changes.

    The device will now restart and will use the new settings thereafter.

These basic settings can also be configured in the IGEL setup application. A handy tool tip is available for virtually every setting. If you would like to know more about a setting or option, simply move your mouse pointer over it and wait a moment.