(new related group 1)

Boot settings

Voriges Thema

Nächstes Thema

Installation procedure
  1. Connect the prepared USB memory stick to the target device and switch the target device on.
  2. Select one of the following options from the boot menu:
  3. Choose your language: Select the language for the installation process.
  4. Confirm the license agreement (up to IGEL Linux 10.03.100) resp. accept the EULA (from IGEL Linux 10.04.100 onwards)
  5. Installation program: Here, you can configure settings for the installation process and start it. Check the target drive to ensure that the system is installed on the desired drive.

    The installation will destroy all existing data on the target drive.

    The following options are available:

    Remember to set the system to legacy/BIOS mode after installation.

    UEFI booting results in a UEFI installation, and legacy/BIOS booting in a legacy/BIOS installation. (Default)

  6. Click on Install firmware.
  7. The installation program will set up IGEL Linux on the target drive. If you see the IGEL Universal Desktop Converter build finished successfully message, the installation is complete. Click on Reboot at the bottom of the installation window.
  8. Remove the USB memory stick.
  9. Close the message window.

    The system will shut down and then boot IGEL Linux.