(new related group 1)

Disk Utility

Voriges Thema

Nächstes Thema

Using “Disk Utility”

To obtain information regarding a hotplug storage device connected to your thin client, proceed as follows:

  1. Start the Disk Utility function. The start options are described under Disk Utility.
  2. Click on the desired hotplug storage device in the left-hand column.

    The information regarding the hotplug storage device is shown in the right-hand column.

To remove a hotplug storage device safely, proceed as follows:

  1. Start the Disk Utility function. The start options are described under Disk Utility.
  2. Click on the Safely Remove Hardware button in the right-hand column.

    The hotplug storage device is disconnected from the thin client. Once it has been disconnected, the storage device can be removed from the thin client.

    If Setup > Devices > Storage Devices > Storage Hotplug > Use Hotplug Storage Device Signal Tone is enabled, a signal tone will signal that the device has been disconnected successfully. If Setup > Devices > Storage Devices > Storage Hotplug > Show Hotplug Storage Device Messages is enabled, a message window will signal that the device has been disconnected successfully. Further information can be found underStorage Hotplug.