Attaching Rubber Feet to UD Housing

The following instructions are valid for UD2, UD3, UD5/6 and UD7. The schematic illustrations are based on the UD3, but the relevant properties, e.g. the relative positions of the power button, are the same for all housings.

You can use IGEL UD2, UD3, UD5/6 and UD7 devices in a horizontal position. For this purpose, you must attach rubber feet to the housing.

For safe operation, use only the rubber feet provided by IGEL Technology GmbH.

The following description shows you how to mount the rubber feet on the thin client housing.

  1. Tilt the housing to the left so that the power button is on the left-hand side.

    On left hand site

  2. Remove the rubber feet from their protective foil.
  3. Stick the feet on the bottom part of the housing near the border of the ventilation slots area:

    Stick Rubber Feet

  4. Put the housing on its feet as shown below.

    Rubber Fett ready

    Make sure that the upper ventilation slots are not covered!